![]() Check the section called "15.04 and newer" above this one in this case. Hi, i am used to entering the ipconfig command on Windows command prompt to get all the network information. Figure - MAC Address ipconfig command resul Question: Q: ipconfig command for Mac. Windows tips and tricks ipconfig command to see if Internet connection is there when you have. Make sure you get the physical address of the correct network adapter - usually there are several listed. If you're using Ubuntu 15.04 or newer the nm-tool has been replaced by the nmcli command which is different. How to IPCONFIG on Apple Mac OS X HDGuideTutorial. To run it just type in a terminal: nm-tool You can get these with nm-tool (in Ubuntu versions prior to 15.04) which BTW is the command line version of network manager. To get a list of devices and their status type: nmcli dev status Replace eth0 with the actual device name you're using, which may not be the same. On 16.04 and newer versions there is a IP4.GATEWAY line which is pretty self explanatory. ![]() The output lists some device parameters including some IP4.DNS entries, which show the DNS servers and a IP4.ADDRESS line which lists the IP and Gateway used (look for the gw = ?.?.?.? part at the end of the line up to 15.10). While this is a basic tutorial, there are some advanced tips and topics included. To get the DNS and Gateway info just type: nmcli dev show eth0 Now the ipconfig command will be covered (the Linux/Mac ifconfig & route commands will be touched on too). The only thing missing from ifconfig are the gateway and DNS servers.
0 Comments
Leave a Reply. |